Toshiba RAS-10SAVP-E Service Manual page 103

Toshiba ilmalämpöpumppujen myynti, huolto ja asennus: Jäähdytinpalvelu RefGroup Oy, Vantaa
No. Part name
‡
Compressor 1) Perform work of item 1 of
2) Extract refrigerant gas.
3) Remove the partition board.
(ST1TØ4 × 8L 3 pcs.)
4) Remove the sound-insulation material.
5) Remove terminal cover of the compressor, and
disconnect lead wire of the compressor from the
terminal.
6) Remove pipe connected to the compressor with
a burner.
• Take care to keep the 4-way valve away from
7) Remove the fixing screw of the bottom plate
and heat exchanger. (ST1TØ4 × 8L 1 pc.)
8) Remove the fixing screw of the bottom plate
and valve fixing plate. (ST1TØ4 × 8L 1 pc.)
9) Pull upward the refrigeration cycle.
10) Remove BOLT (3 pcs.) fixing the compressor
* Precautions when assembling the compressor.
ˆ
Reactor 1) Perform work of item 1 of
2) Remove screws fixing the reactor.
(ST1TØ4 × 8L 4 pcs.)
Procedure
naked flames. (Otherwise, it may malfunction.)
to the bottom plate.
Tighten the compressor bolts using a tighten-
ing torque of 4.9 N•m.
www.ilmalämpöpumput.com
 ‚ ƒ „ …
and , , , .
‚ ƒ
, and .
– 103 –
Remarks
Partition board
Valve fixing plate
Compressor
Reactor