Host Parameters - Motorola Symbol DS6707 Product Reference Manual

RS-232 Host Parameters
Various RS-232 hosts use their own parameter default settings. Selecting standard, ICL, Fujitsu, Wincor-Nixdorf
Mode A, Wincor-Nixdorf Mode B, OPOS/JPOS, Olivetti, Omron or Common Use Terminal Equipment
(CUTE-LP/LG bar code readers) sets the defaults listed in
Terminal Specific RS-232
Table 8-2
Parameter
Transmit Code ID Yes
Data Transmission Data/Suffix
Format
Suffix CR (1013)
Baud Rate 9600
Parity Even
Hardware RTS/CTS
Handshaking Option 3
Software None
Handshaking
Serial Response 9.9 Sec.
Time-out
Stop Bit Select One
ASCII Format 8-Bit
Beep On <BEL> Disable
RTS Line State High
Prefix None
In the Nixdorf Mode B, if CTS is low, scanning is disabled. When CTS is high, scanning is enabled.
If you scan Nixdorf Mode B without connecting the digital imager scanner to the proper host, it may appear
unable to scan. If this happens, scan a different RS-232 host type within 5 seconds of cycling power to the
digital imager scanner.
The CUTE host disables all parameter scanning, including Set Defaults. If you inadvertently select CUTE,
scan *Enable Parameter Scanning (01h) on page 4-5, then change the host selection.
Wincor-
ICL Fujitsu Nixdorf
Mode A
Yes Yes
Data/Suffix Data/Suffix
CR (1013) CR (1013)
9600 9600
None Odd
None RTS/CTS
Option 3
None None
2 Sec. 9.9 Sec.
One One
8-Bit 8-Bit
Disable Disable
Low Low
None None
Table 8-2.
Wincor-
Nixdorf Mode Olivetti
B/OPOS/JPOS
Yes Yes
Data/Suffix Prefix/Data/
Suffix
CR (1013) ETX (1003)
9600 9600
Odd Even
RTS/CTS None
Option 3
None ACK/NAK
9.9 Sec. 9.9 Sec.
One One
8-Bit 7-Bit
Disable Disable
Low = No data to Low
send
None STX (1002)
RS-232 Interface 8 - 5
Omron CUTE
Yes Yes
Data/Suffix Prefix/Data/
Suffix
CR (1013) CR (1013)
ETX (1003)
9600 9600
None Even
None None
None None
9.9 Sec. 9.9 Sec.
One One
8-Bit 7-Bit
Disable Disable
High High
None STX (1002)