Accessories; Options / Accessories; Construction Version; Field Installed Options - Lincoln Electric INVERTEC V350-PRO Operator's Manual

C-1

OPTIONS / ACCESSORIES

• K2176-1 Twist-Mate to Lug Adapter
• K1764-1 Inverter and Feeder Cart
• K1557 Swivel Kit
• K1702-1 Dual Cylinder Kit (For K1764-1)
• K1838-1 Valet Style Undercarriage
Welding Cable Connectors:
• K852-70 1/0-2/0 cable
• K852-95 2/0-3/0 cable
Twist-Mate Plugs and Receptacles are not used
with Code 11445.

CONSTRUCTION VERSION

K930-1 TIG Module (Requires external 115VAC supply)
K428,K446, K449 LN-25(Off the Arc)
FACTORY VERSION and
ADVANCED PROCESS VERSION
K857 Remote Output Control
K814 Arc Start Switch
K812 Hand Operated Amptrol
K870 Foot Operated Amptrol
Note: All of the above remote controls connect directly
to the 6-pin MS-style connector, with either a K864 or
K876 adapter and connect it to the 14 pin wire feeder
MS-style connector. (See Diagram in Section F-1)
K930-[ ]
K428, K446, K449
K617 (-1 or -2) K618 (-1 or -2) LN-742
K440 (-1), K567-1
K1559-1, K1564-1
K1499-1, K1521-1
K1587-1
*Not recommended for pulse welding
FIELD INSTALLED OPTION (
• K1762-2 TIG Gas Control Kit
• K1763-1 Advanced Process Panel

ACCESSORIES

TIG Module
LN-25 *
LN-7 GMA
LN-10
DH-10
Cobramatic
)
ALL VERSIONS
INVERTEC® V350-PRO

QUICK DISCONNECT PLUGS

A quick disconnect system is used for the welding
cable connections. The K852-70 is designed to
accept a welding cable size of 1/0 to 2/0.
1. Remove 25mm (1 in.) of welding cable insulation.
2. Slide rubber boot onto cable end. The boot end
may be trimmed to match the cable diameter.
Soap or other lubricant will help to slide the boot
over the cable.
WELDING CABLE
25 mm
1 in.
3. Slide the copper tube into the brass plug.
4. Insert cable into copper tube.
COPPER TUBE
5. Tighten set screw to collapse copper tube. Screw
must apply pressure against welding cable. The
top of the set screw will be well below the surface
of the brass plug after tightening.
6. Slide rubber boot over brass plug. The rubber
boot must be positioned to completely cover all
electrical surfaces after the plug is locked into the
receptacle.
C-1
BOOT
TRIM
SET SCREW
BRASS PLUG