Setting Ip Network Properties - 3Com WL-560 User Manual

30 C 3: C
HAPTER ONFIGURING THE
Setting IP Network
Properties
B
RIDGE
Table 9 System Properties Page (continued)
Web GUI This setting allows users to enable the
Protocol secure data exchange scheme over SSL
during a configuration session.
■
■
Under System Configuration, click IP Network. The IP Network Properties
page appears, where you can change the settings shown in Table 10.
If you change the IP address and click Apply, you cannot continue to
configure the device using the old IP address. Therefore, you must do the
following steps after changing the IP address:
1 Close your browser.
2 Return to the 3Com Wireless Infrastructure Device Manager and click
Refresh.
3 Select the device and click Configure to start a new configuration session.
Table 10 describes the IP Network properties.
Table 10 IP Network Properties Page
Setting
IP Network Setting
IP Address
Subnet Mask
Gateway IP
Address
HTTPS — enables SSL technology.
HTTP — disables SSL technology.
Description
This setting allows you to change the IP address of the device.
To let the device get an IP address automatically from a DHCP
server, select Obtain an IP address automatically and click
Apply.
To specify an IP address, select Specify an IP address, enter the
IP address parameters in the spaces provided, and click Apply.
When Specify an IP address is selected, enter the IP address in
the space provided, and click Apply.
When Specify an IP address is selected, enter the Subnet Mask
in the space provided, and click Apply.
When Specify an IP address is selected, enter the Gateway IP
Address in the space provided, and click Apply.
HTTP