Setting Ip Network Properties; Refreshing The Client List - 3Com WL-308 Manual

Setting IP Network
Properties
Refreshing the Client
List
Property Description
Device Location Optionally, you can enter the location of the
device.
Help File Location
Help File Path The location of the Configuration
Management System help files on the web
server or on the local drive.
If you want to have access to help when you
click the ? in the configuration pages, you must
install the help from the 3Com CD in the
default location on the local computer. If you
install the help in a different location on the
local disk or on a web server, you must set the
Help File Path to the correct location.
Under System Configuration, click IP Network. The IP Network Properties page
appears, where you can change the settings shown in the table below.
If you change the IP address and click Apply all Changes, you cannot continue to
configure the device using the old IP address. Therefore, you should click Enter if
want to continue configuring this device after you make this change. Otherwise,
you must do the following:
1 Close your browser.
2 Return to the 3Com Wireless Infrastructure Device Manager and click Refresh.
3 Select the device and click Configure to start a new configuration session.
Setting
IP Network Setting
IP Address
Subnet Mask
Gateway IP Address
The workgroup bridge supports up to four specific clients (for example, computers
and printers) and keeps track of the clients with a list of their MAC addresses.
After the client limit is reached, you must refresh the client list to allow a new
client to associate with the network. For example, in a hub configuration with four
clients connected, if you disconnect a desktop computer and connect a new
laptop in its place, you must refresh the client list to establish network association
for the laptop. Follow these steps:
1 Disconnect a client by unplugging its Ethernet cable from the hub or the bridge.
2 Use the 3Com Wireless Infrastructure Device Manager to select the workgroup
bridge and launch its configuration management system.
Web Server: Help files are located on the
network at the specified Help File Path.
Local Drive: Help files are located on the
client at the specified Help File Path.
Description
This setting allows you to change the IP address of the device.
To let the device get an IP address automatically from a DHCP server,
click Obtain an IP address automatically and click Enter.
To specify an IP address, click Specify an IP address, enter the IP address
parameters in the spaces provided, and click Enter.
Parameters for use when you click Specify an IP address. Enter the
parameters in the spaces provided, and click Enter.

Setting IP Network Properties

Default Value
None
Local Drive
c:\Program Files\3Com\
Management Help
15