Tuning Your Television For The Dvd-Vcr; Deck Control Keys - Samsung DVD-V440 Instruction Manual

Plug & Auto Set up
Time
12 : 00
Auto preset can be performed by pressing
the VCR continuously for 5 seconds or more
with no tape inserted.
Tuning Your Television for the
DVD-VCR
You must tune your television for the DVD-VCR only if
you are not using a RCA cable
To view pictures from your DVD-VCR when a
RCA cable is used, the television must be set to
the audio/video mode (AV).
1
Switch on the television.
2
Switch on the DVD-VCR by pressing
STANDBY/ON on the front of the DVD-VCR or
STANDBY/ON on the remote control.
3
Select a programme position on the television to be
reserved for use with your DVD-VCR.
4
Insert the video cassette in the DVD-VCR. Check
that the DVD-VCR starts reading the cassette; if
not, press
❿ II
5
Start a scan on your television or set the television
to UHF channel 36 (Australia:UHF 38 CH).
6
Fine tune the television until the pictures and sound
are obtained clearly.
Downloaded From Disc-Player.com Samsung Manuals
Auto setup
Please wait
00 %
Clock Set
Date Year
1/JAN 2004 THU
button.
7
If you cannot find the pictures and sound, or there
is interference from nearby channels, it may be
necessary to change the setting of the DVD-VCR
output channel (see Setting the DVD-VCR Output
Channel on page 14 and Problems and Solutions
on page 47).
8
When the picture and sound are perfectly clear,
store this channel at the desired programme
position on the television.
Result: That programme is now reserved for use
with your DVD-VCR.

Deck Control Keys

on
The DVD-VCR uses one set of controls to operate both
decks. The following keys are helpful in successfully
controlling each deck.
1
Standby/on Button
Press the STANDBY/ON button on the remote
control or front panel to turn on the DVD-VCR.
2
DVD Button
Press the DVD button on the remote control when
you want to control the DVD deck.
The DVD indicator will light on the Front Panel
Display to show that the DVD deck is selected.
3
VCR Button
Press the VCR button on remote control when you
want to control the VCR deck.
The VCR indicator will light on the Front Panel
Display to show that VHS deck is selected.
4
INPUT SEL. BUTTON
Press the INPUT SEL. button repeatedly to cycle
through all of your input sources, including the
Tuner (PR##), Line 1 (rear AV input), and Line 2
(front AV input).
• Input select is only available when the VCR deck
is selected.
Before using the VCR operation of 10~28 pages,
press the VCR button on the remote control to
select VCR mode.
Before using the DVD operation of 29~45
pages, press the DVD button on the remote
control to select and watch DVD.