Lincoln Electric RANGER IM511-D Operator's Manual page 36

RANGER 9 / LN-25 WITH 42 VOLT REMOTE OUTPUT
CONTROL MODULE CONNECTION DIAGRAM
Do not operate with panels open.
Disconnect NEGATIVE (-) BATTERY LEAD
before servicing.
Do not touch electrically live parts.
14 PIN
AMPHENOL
TO WORK
CAUTION :
ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE
AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE
DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN
THE ENGINE WELDER OPERATING MANUAL.
N.A. USE POLARITY SWITCH TO SET FOR DESIRED ELECTRODE POLARITY. POSITION THE OUTPUT SELECTOR SWITCH TO A CV POSITION.
PLACE WELDER TERMINALS SWITCH TO "REMOTELY CONTROLLED" POSITION.
N.B. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE
APPLICATIONS. SEE OPERATING MANUAL.
N.C. IF OPTIONAL REMOTE OUTPUT CONTROL IS USED, PLACE OUTPUT CONTROL SWITCH IN "OUTPUT CONTROL REMOTE" POSITIION.
N.D. PLACE IDLER SWITCH IN "AUTO" OR "HIGH" IDLE POSITION AS DESIRED.
K915-1 AMPTROL ADAPTER FOR K799 HI-FREQ KITS
WARNING
TURN THE ENGINE OR POWER SWITCH
OF THE WELDING POWER SOURCE "OFF"
BEFORE CONNECTING OR DISCONNECTING
PLUGS TO WELDING POWER SOURCE.
ELECTRIC SHOCK
can kill
K963 HAND
AMPTROL
OR
6-SOCKET
RECEPTACLE
K870 FOOT
AMPTROL
THIS ADAPTER ALLOWS AN AMPTROL TO OPERATE A
K799 HI-FREQ KIT WHILE REMOTELY CONTROLLING THE
OUTPUT CURRENT OF A LINCOLN POWER SOURCE.
(THE POWER SOURCE MUST BE EQUIPPED WITH A
6-PIN REMOTE CONTROL AMPHENOL CONNECTOR.)
SEE THE HI-FREQ KIT AND POWER SOURCE INSTRUC-
TION MANUAL FOR INFORMATION ON PROPER SWITCH
AND CONTROL SETTINGS.
WARNING
TO LN-25 INPUT
CABLE PLUG
K626-XX INPUT CABLE ASSEMBLY
ELECTRODE
TO WORK
K915-1
AMPTROL
ADAPTER
– 34 –
Keep guards in place.
Keep away from moving parts.
Only qualified personnel should install,use
or service this equipment.
ELECTRODE CABLE
TO WIRE FEED UNIT
POWER SOURCE
6-PIN
PLUG
- +
BYPASS *
CAPACITOR
KIT
HI-FREQ KIT *
INPUT POWER
5-PIN
PLUG
K799 HI-FREQ KIT
* SEE INSTRUCTIONS INCLUDED WITH HI-FREQ
KIT FOR CONNECTION INFORMATION.
1 2 - 1 6 - 9 3
M 1 7 2 1 4
ELECTRODE LEAD *
WORK SENSE LEAD *
4-19-96D
S20909