Changing Your Station Passcode; Dial By Voice - Samsung DS24D User Instruction

ACCOUNT CODES
When it is equipped with optional equipment, your SAMSUNG DS 616 sys-
tem allows calls to be charged to different accounts. You can enter an ac-
count code in two ways. To enter an account code by interrupting the con-
versation:
• While on an outside call, hookflash, receive confirmation tone and
dial 47.
• Dial the account code (it may be a maximum of 12 characters includ-
ing ✱ and #).
• Hookflash to return to the conversation.
• If you make an error, repeat the procedure with the correct code. Only
the last account code dialed will be recorded.
To enter an account code after the outside party hangs up.
• After the outside party hangs up, hookflash, receive confirmation tone
and then dial 47.
• Dial the account code (it may be a maximum of 12 characters includ-
ing ✱ and #).
NOTE: If you wait for the outside party to hang up, you must complete this
procedure within ten seconds. You cannot repeat if you make a mistake.
IN/OUT OF GROUP
If your station is assigned to a hunt group, this feature will allow you to dial
an access code plus the group number, e.g., 501, plus 0 to temporarily pre-
vent your station from receiving any group calls. You will still be able to
receive calls that are dialed directly to your station. To reenter the group, dial
an access code plus the group number, e.g., 501, plus 1.

DIAL BY VOICE

If your station is assigned to a Dial by Voice group, this feature allows you
to use Dial by Voice. Before using this feature, you must record a name and
assign that name to a personal speed bin. This feature can be accessed
only by a dial code. When you are recording a name, do not pause between
the first and last names because the system will interpret the pause as the
end of the recording. Practice saying names as one word, e.g. Saint cho,
Robert Kim, Candy Kim.
IMPORTANT: To record a name for one of your speed dial numbers the fol-
lowing procedure must be followed in one complete step. Stopping causes
recording to fail.
20
Home Page
Lift the handset and dial 642. Dial the station passcode (1234). Dial the per-
sonal speed bin number. Upon completion of this entry, you will hear three
short beeps. Immediately record the name. If you are successful, you will
hear a short burst of tone confirming the recording.
To place a call using Dial by Voice:
• Lift the handset.
• Dial 681 and speak the name.
• If the name is recognized, the call will be placed. If the name is not
recognized, you will hear error tone. Hang up and try again.
NOTE: This feature requires optional hardware and/or software. Ask your
installation and service company for details.
CHANGING YOUR STATION
PASSCODE
Your default station passcode is 1234. You can change your station pass-
code whenever you desire.
To change your station user passcode:
• Lift handset to go offhook then dial 15101.
• Then dial your existing station passcode.
• Then dial a new passcode (must be four digits).
• Redial your new passcode to verify. If successful, you will hear a con-
firmation tone.
• Hang up to store your new passcode.
NOTE: If you are presented with an error tone at any time, go on-hook and
resume from the beginning.
Table of Contents Standard Telephone
21