Program Personal Speed Dial - Samsung DS24D User Instruction

Open customer programming and follow the instructions below.
ACTION
1. Press Transfer and then dial 105
Display shows
2. Dial the station number (e.g., 205) OR
press UP or DOWN to select the station
and press the right soft key to move the
cursor OR press the left soft key to go
to step 4
3. If the selected station has no speed dial
bins, this display will be shown and a new
station may be selected
4. Dial the location number (e.g., 05) OR
press UP or DOWN to select the location
and press the right soft key to move the
cursor OR press the left soft key to return
to step 2
5. Enter the trunk access code (e.g., 9)
followed by the number to be dialed
(e.g., 4264100) OR press the right
soft key to return to step 2 OR press the
left soft key to return to step 3 OR press
Hold to clear an entry (if an error is made,
use the DOWN key to step back)
6. Press the F key to access Program Station
Speed Dial Names OR press Transfer to save
and exit programming OR press Speaker to save
and advance to the next program
DEFAULT DATA: NO SPEED DIAL NUMBERS PROGRAMMED
21
DISPLAY
[201] SPEED DIAL
00 :
[205] SPEED DIAL
00 :
[205] SPEED DIAL
NO SPEED BLOCK
[205] SPEED DIAL
05: _
[205] SPEED DIAL
05 : 9-4264100_
Home Page

PROGRAM PERSONAL SPEED DIAL

NAMES FOR OTHER STATIONS
Each individual station user can program his/her own names but in cases
where it is impractical or for single line telephone users, this program allows
a system administrator to view or change any station's speed dial names.
The station speed dial codes are 00–49. Each station begins with ten num-
bers (00–09) and can be assigned more in blocks of ten up to a maximum
of fifty numbers.
PROGRAM KEYS
UP & DOWN - Used to scroll through extension numbers and speed dial bins.
KEYPAD - Used to enter selections.
SOFT KEYS - Move cursor left and right.
Speaker - Used to store data and advance to next program.
Hold - Used to clear previous entry.
Redial - Used to select ALL.
ACTION
1. Press TRSF and then dial 106
Display shows
2. Dial the station number (e.g., 205) OR
press UP or DOWN to select the station
and press the right soft key to move the
cursor
3. If the selected station has no speed dial
bins, this display will be shown and a new
station may be selected
4. Dial the speed dial location (e.g., 05) OR
use UP or DOWN to scroll through the
location numbers and use the right soft
key to move the cursor OR press the left
soft key to return to step 2 above
5. Enter the name using the procedure in
Program Station Names and press the
right soft key to return to step 2 OR
press the left soft key to return to step 3
System Admin
Table of Contents
DISPLAY
[201] SPEED NAME
00:
[205] SPEED NAME
00:
[205] SPEED DIAL
NO SPEED BLOCK
[205] SPEED NAME
01:_
[205] SPEED NAME
01:SAM SMITH
22