Printer Unit - Oki OKIOFFICE 84 Service Manual

Hide thumbs Also See for OKIOFFICE 84:

Table of Contents

Service Guide OKIOFFICE 84

Chapter 4 Disassembly

4.3.18 Printer Unit

Disassembly procedure

a) First, carry out procedure up to the point of the 4.3.2 (ID Unit, Cover-Rear, Cover-NCU and

Cover-MAIN).

b) Remove Bracket-Package with three screws, then disconnect Cable-Flat from connector on

R51-Board (M-CNT).

c) Dismount the high-voltage power supply board. (See Section 4.3.10

d) Disconnect cable 1 and 2 from connector on Board-R51 (M-CNT), and disconnect cable 3 from

Connect on Power Supply Unit.

e) Remove the Printer Unit by removing three screws.

f) Detach the four clamps from underneath, push inward on the top two tabs while lifting up to remove

the Holder-Assy.