Motorola AP-51 Series Product Reference Manual page 191

Enable Hotspot
CAUTION A WLAN cannot be enabled for both mesh and hotspot support at the
!
NOTE If 802.11a is selected as the radio used for the WLAN, the WLAN cannot
use a Kerberos supported security policy.
4. Configure the Security
WLAN.
NOTE A WLAN configured to support Mesh should not have a Kerberos or
802.1x EAP security policy defined for it, as these two authentication
schemes are not supported within a Mesh network.
Security Policy
MU Access Control
Kerberos User Name
Select the Enable Hotspot
it be a new or existing WLAN) to be configured for hotspot support.
Clicking the Configure Hotspot
the parameters of the hotspot can be defined. For information on
configuring a target WLAN for hotspot support, see
WLAN Hotspot Support on page
hotspot is and what it can provide your wireless network, see
Hotspot Support on page
same time. Only one of these two options can be enabled at one time,
as the GUI and CLI will prevent both from being enabled.
field as required to set the data protection requirements for the
Use the scroll down
scheme best suited for the new or revised WLAN. Click the
button to jump to the New Security Policy screen where a new
policy can be created to suit the needs of the WLAN. For more
information, see Configuring WLAN Security Policies on page 5-35
Select an ACL policy suiting the WLAN's MU introperability
requirements from the drop-down menu. If the existing ACL
policies do not satisfy the requirements of the WLAN, a new ACL
policy can be created by pressing the
information, see Configuring a WLAN Access Control List (ACL) on
page 5-37.
Displays the read-only Kerboros User Name used to associate the
wireless client. This value is the ESSID of the access point.
checkbox to allow this WLAN (whether
button launches a screen wherein
5-46. For an overview of what a
1-22.
Security Policies menu to select the security
Create
Network Management
Configuring
Create
.
button. For more
5-33