Advertisement
Step
1
1.
Select an appropriate location.
2.
Connect your workstation to any available RJ-45 port on the switch using twisted-
pair cable.
All end-node devices must be within 328 ft (100 meters) of the connected hub.
Using the hub in a stand-alone configuration, you can network up to 5 workstations.
To connect a computer directly to the switch, plug one end of the cable into the
switch then plug the other end of the cable into the computer's network adapter.
3
Plug in the AC power adapter.
NOTE: Each time your SpeedStream
Test. After the test is complete, the Power LED will light up.
4.
As connections to the 2105's ports are made, each port's corresponding
LINK/ACT will light up. The remaining LEDs will also light up according to how
your data is being transferred, e.g. full or half duplex, 10 Mbps or 100 Mbps.
Uplinking to other Switches and Hubs
NOTE: Using the Uplink port will automatically disable the port directly next to it
since the Uplink port is a shared port.
Hardware Installation
2105 powers up, it will run a Diagnostic/Self-
®
SpeedStream
2105 Ł
®
Ethernet Switch Ł
(5-port 10/100Base-T)
Power
RJ-45
Advertisement
