Table of Contents
Advertisement
Samsung iDCS100
USING AUTHORISATION CODES
1. Lift the handset and dial
2. Dial the 4-digit authorisation code.
If you enter a correct code, you will hear a confirmation tone and then receive dial tone
and you can make an outside call in the usual manner. The station then follows the
class of service for that au
error tone. This code will print on SMDR reports if programmed to do so in MMC 725.
For information on setting up authorisation codes, see the
gramming
section of this guide.
USING THE TIELINE
OUTGOING
Your office can be connected to another system with a tieline. Use this line to make
calls to stations in the other system. If programming allows, you can access lines in the
other system to make outside calls. Tieline calls can be put on hold, transferred and
conferenced in the same manner as other outside calls.
•
Lift the handset or press the SPEAKER key.
•
Dial the tieline access code or press the tieline key (if programmed).
•
When you receive dial tone from the other system, you can dial extension numbers
or access outside lines. You must know the extension numbers and the line access
codes for the other system.
•
Finish the call by replacing the handset or pressing the ANS/RLS key.
Note: Outgoing calls are controlled by the station's dialling class.
INCOMING
Station users in the other system can access the tieline and make intercom calls to sta-
tions in your system.
Answer tieline calls ringing at your station as you would any other outside call. They
can be put on hold, transferred and conferenced in the same manner as other outside
calls.
IN AND OUT ON TIELINE
Users accessing the tieline from the other system can get a line in your system and
make outgoing calls. These calls can be controlled by assigning a dialling class to the
tieline. Your system installer must do this for you.
or press the AUTH soft key.
thorisation code. If you enter an incorrect code, the station returns
System Administration Guide
System Administrator Pro-
7
Advertisement
Table of Contents
