Preparation; Attaching The Stand Unit - 52/46/40Le830M - Sharp AQUOS LC-60LE830M Operation Manual

Preparation

Attaching the stand unit —
52/46/40LE830M
• Before performing work, spread cushioning over the surface
on which you will be laying the TV. This will prevent it from
being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation
of the stand may result in the TV falling over.
1
Confirm that there are screws with the stand unit.
For 52/46 inch models
(four long screws, four middle screws and one
short screw)
For 40 inch models
(three long screws, three middle screws and one
short screw)
2
Attach the supporting post for the stand unit onto
the base using the long screws with a screwdriver
as shown.
Supporting
post

40 inch models
3
Insert the stand into the openings on the bottom
of the TV (hold the stand so it will not drop from
the edge of the base area).
Soft cushion

40 inch models
6

52/46 inch models

52/46 inch models
4
Insert and tighten middle screws into the holes on
the rear of the TV.

40 inch models
5
Attaching the stand cover.
1
Insert the stand cover.
2
Insert and tighten a short screw into the hole of the
stand cover.
NOTE
• To detach the stand unit, perform the steps in reverse order.
• A screwdriver is not supplied with this product.

52/46 inch models