Attaching The Stand Unit - 60Le830M; Fixing The Tv To The Table - Sharp AQUOS LC-60LE830M Operation Manual

Preparation
Attaching the stand unit —
60LE830M
• Before performing work, spread cushioning over the surface
on which you will be laying the TV. This will prevent it from
being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation
of the stand may result in the TV falling over.
1
Confirm that there are screws with the stand unit.
For 60 inch models
(four long screws, four middle screws and two
short screws)
2
Attach the supporting post for the stand unit onto
the base using the long screws with a screwdriver
as shown.
Supporting
post
3
Insert the stand into the openings on the bottom
of the TV (hold the stand so it will not drop from
the edge of the base area).
Soft cushion
4
Insert and tighten middle screws into the holes on
the rear of the TV.
5
Attaching the stand cover.
1
Insert the stand cover.
2 Insert and tighten two short screws into the holes of
the stand cover.
NOTE
• To detach the stand unit, perform the steps in reverse order.
• A screwdriver is not supplied with this product.

Fixing the TV to the table

1
2
Place the TV on the table.
2
Pull the attached restraining bracket out so that it
is at a 90 degrees angle.
1 3
Insert commercially available screws in the holes
of the restraining bracket and tighten the screws
to secure the TV to the table.
• Use commercially available screws to firmly secure the
TV.

Restraining bracket (attached)

Screws (commercially available)
CAUTION
• As this product is heavy, use a table that is wide
enough to support the product and capable of
withstanding the product's weight. The table should be
set where it will not be overturned.
• Be sure to use at least two people when moving the TV.
7