Heat Sink - HP EliteDesk 800 G1 Maintenance & Service Manual

Heat sink

Description
Heat sink
The heat sink is secured with four captive Torx screws. Be sure to remove and replace the screws in the
order indicated on the heat sink.
To remove the heat sink:
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
3. In the order indicated on the heat sink, loosen the four captive Torx screws (1), and then lift the
heat sink out of the computer (2).
CAUTION:
heat sink.
CAUTION:
grease on the surface of the processor or the heat sink.
To replace the heat sink, reverse the removal procedures.
Access panel on page
Be sure the loosen the screws in the order indicated by the numbers stamped on the
To reduce a degradation in thermal performance, be sure not to touch the thermal
Preparing to disassemble the computer on page
26).
Spare part number
768426-001
25).
Heat sink
43