Toshiba MMY-MAP0804HT8JP Service Manual page 133

4
Push the TIME
to that you want.
5
Push the button.
6
UNIT LOUVER
Push the button (left side of the button) repeatedly to select another indoor UNIT No. to
change.
4 6
Repeat steps to
7
UNIT LOUVER
Push the button (left side of the button) to check the changed addresses.
8
If the addresses have been changed correctly, push the
To change all the indoor unit addresses using an arbitrary wired remote controller.
(The method is available when the addresses have already been set automatically.)
(When communication wirings of 2 or more refrigerant lines are interconnected for central control)
NOTE
You can change the addresses of indoor units in each refrigerant line using an arbitrary wired remote controller.
* Enter the address check/change mode and change the addresses.
If no number appears on UNIT No., no outdoor unit exists on the line. Push
2
following step .
(Execute it while the units are stopped.)
1
Push and hold the TIME
At first, the line 1 and CODE No.
2
UNIT LOUVER
Push (left side of the button) and
/ buttons repeatedly to change the value indicated in the SET DATA section
to change the indoor unit addresses so as to make each of them unique.
SET DATA
TEMP.
1
FILTER
RESET TEST
3
and buttons at the same time for more than 4 seconds.
(Address Change) are indicated on the LCD display.
button to finish the procedure.
CODE No.
SETTING
UNIT No.
R.C. No.
ON / OFF
TIMER SET
TIME
SET CL
Cancels the line selection
SWING/FIX
buttons repeatedly to select a system address.
– 132 –
2
button and select another line