Connecting MZ-80P6 to the Computer
1. When connecting to MZ-80B or MZ-80A.
STEP 1. Assemble the I/O card to the extension unit.
Return all the screws removed for assembling as
before. The right picture shows the assembled I/O
card.
With MZ-80B, use No. 3 si it of six si its and, with
MZ-80A, use
[\10.
2 slit of four slits for assembling
the I/O card.
Extension Unit: MZ-80EU for MZ-80B
MZ-80AEU for MZ-80A
STEP 2. Connect the signal cable to the signal terminal for
the I/O card.
You can use either the right or
left cable connector, but pay attention to the direc
tion when connecting. They are non-reversible con
nectors.
STEP 3. Pass the suppl ied screws
'
through the holes in the
right and left of this connector, and fasten the
connector by tightening these screws. Be sure to
tighten these screws. (Tighten screws in 2 places)
STEP 4. Connect the other end of the signal cable to the
signal term i nal (I/O PO RT 1) in the back of pri nter
MZ-80P6. As in STEP 3, use the supplied screws,
and fasten both sides of this connector by tighten
ing the screws. (Tighten screws in 2 places.)
(Back of computer)
~
e[
le
49!
le
el
iri:~;o
le
si
10
I/O card
--=::::::::'--':'
---
~'-
Tighten with screws.
---
-
STEP 5. Finally, connect the FG terminals of the computer
and MZ-80P6 with the supplied braided wire (Fig.
1
1Uih'1~~~R~~J~
~U~~~~~~\\~~
on the right). The lug terminal on one side of the
braided wire is "U" shaped, and the other end is
round shaped
.
Connect the "U" shaped lug termi
nal to the FG terminal of the computer, and the
round shaped lug terminal to the FG terminal of
the MZ-80P6. When connecting to the FG terminal
of the MZ-80P6, tighten the lug terminal of the
braided wire with the screw of FG. This connection
of the braided wi re "must be
done.
4