Table of Contents
Advertisement
Command
Example
7'
-
Meaning
{;.L.,_....
:-::!~
COPY/P
COpyJP command is used for output of the pattern (of
one screen) displayed on the CRT screen of the MZ-80B
(strictly speaking, data in V-RAM area) to the printer.
Therefore, the pri nted pattern is a copy of the C RT
screen. There are four styles of copy as explained below.
Dot space of the horizontal I ine is reduced wh.en it is set
in the reduced mode.
COpyJP 1
If the CRT screen shows data in the character V-RAM
area, the data of that one screen is output to the printer.
COpy /P 2
Within the graphic V-RAM area (graphic area 1, graphic
area 2) it outputs data of the one screen contained in
graph ic area 1 to the pri nter and performs bit image
pattern pri nt ing. (Refer to the footnote 3.)
COpy/P 3
It outputs data of the one screen contained in graphic
area 2 to the printer and performs bit image pattern
printing. (Refer to the footnote 3.)
COpy /P 4
Determines the logical sum (OR) of each bit of data
contained in graph ic area 1 and 2 as output data to the
printer. Consequently, the pattern is printed as a pattern
with the two patterns obtained from COpy /P 2 and
COpy/P 3 superimposed. (Refer to the footnote 3.)
PAGE/P
PAG EJP N
Determines the value of N as the max imum number of
lines that can be pri nted on one page. The nu mber of
lines here is the number of lines in the space line mode.
N is any integer from 1 to 128. The initial condition is
66 lines for one page.
(Note) 1. With BASIC, all the functions of the MZ-80P6 can not be used. If you want other controls,
make the program yourself.
2. With PR INT/P CH R$(M), this command is ignored when M is 0-4,7-15,22-31.
3. The commands "COPY/P2", ICOPYJP3", and ICOPY/P4" are not included in the BASIC of
MZ-80A.
32
Advertisement
Table of Contents
