Port Status Summary - ZyXEL Communications GS2200-24 User Manual

Chapter 7 System Status and Port Statistics

7.3 Port Status Summary

To view the port statistics, click Status in all web configurator screens to display
the Status screen as shown next.
Figure 33 Status
The following table describes the labels in this screen.
Table 6 Status
LABEL
Port
Name
Link
State
LACP
TxPkts
RxPkts
Errors
Tx KB/s
66
DESCRIPTION
This identifies the Ethernet port. Click a port number to display the Port
Details screen (refer to
This is the name you assigned to this port in the Basic Setting > Port
Setup screen.
This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps
or 1000M for 1000Mbps) and the duplex (F for full duplex or H for half).
It also shows the cable type (Copper or Fiber) for the combo ports.
If STP (Spanning Tree Protocol) is enabled, this field displays the STP
state of the port (see Section 13.1 on page 117
If STP is disabled, this field displays FORWARDING if the link is up,
otherwise, it displays STOP.
This fields displays whether LACP (Link Aggregation Control Protocol) has
been enabled on the port.
This field shows the number of transmitted frames on this port.
This field shows the number of received frames on this port.
This field shows the number of received errors on this port.
This field shows the number of kilobytes per second transmitted on this
port.
Figure 34 on page 67).
for more information).
GS2200-24 User's Guide