Configuring Dhcp Global Relay - ZyXEL Communications GS2200-24 User Manual

Chapter 31 DHCP

31.5 Configuring DHCP Global Relay

Configure global DHCP relay in the DHCP Relay screen. Click IP Application >
DHCP in the navigation panel and click the Global link to display the screen as
shown.
Figure 131 IP Application > DHCP > Global
The following table describes the labels in this screen.
Table 85 IP Application > DHCP > Global
LABEL
Active
Remote
DHCP
Server 1 .. 3
Relay Agent
Information
Information
Apply
Cancel
264
DESCRIPTION
Select this check box to enable DHCP relay.
Enter the IP address of a DHCP server in dotted decimal notation.
Select the Option 82 check box to have the Switch add information (slot
number, port number and VLAN ID) to client DHCP requests that it relays
to a DHCP server.
This read-only field displays the system name you configure in the General
Setup screen.
Select the check box for the Switch to add the system name to the client
DHCP requests that it relays to a DHCP server.
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
GS2200-24 User's Guide