Click Save at the top right corner of the web
8
configurator to save the configuration permanently.
Connect your DHCP server to port 5 and a computer (as DHCP client) to either
9
port 6 or 7. The computer should be able to get an IP address from the DHCP
server. If you put the DHCP server on port 6 or 7, the computer will not able to
get an IP address.
10 To check if DHCP snooping works, go to Advanced Application > IP Source
Guard, you should see an IP assignment with the type dhcp-snooping as shown.
Figure 26 Tutorial: Check the Binding If DHCP Snooping Works
You can also telnet or log into the Switch's console. Use the command "show dhcp
snooping binding" to see the DHCP snooping binding table as shown next.
sysname# show dhcp snooping binding
MacAddress
-----------------
00:02:00:00:00:1c
Total number of bindings: 1
6.3 How to Use DHCP Relay on the Switch
This tutorial describes how to configure your Switch to forward DHCP client
requests to a specific DHCP server. The DHCP server can then assign a specific IP
address based on the information in the DHCP requests.
6.3.1 DHCP Relay Tutorial Introduction
In this example, you have configured your DHCP server (192.168.2.3) and want
to have it assign a specific IP address (say 172.16.1.18) to DHCP client A based
GS2200-24 User's Guide
IpAddress
---------------
------------
10.10.1.16
6d23h59m20s
Lease
Type
VLAN
-------------
----
dhcp-snooping
Chapter 6 Tutorials
Port
-----
100
7
59