Removing The Unit - Audiovox DVD1627 Owner's Manual/Warranty Document

10. Reconnect the cable to the vehicle battery's negative (-) terminal. Then replace
the outer trim ring and install the unit's front panel (see the steps of "installing the
front panel").

Removing the unit

1. Make sure the ignition is turned off, then disconnect the cable from the vehicle
battery's negative (-) terminal.
2. Remove the metal strap attached the back of the unit (if attached).
3. Press the release button to remove the front panel.
4. Lift the top of the outer trim ring then pull it out to remove it.
5. Insert both of the supplied keys into the slots at the middle left and right sides of
the unit, then pull the unit out of the dashboard.
DIN REAR-MOUNT (Method B)
If your vehicle is a Nissan, Toyota, follow these mounting instructions.
Use the screw holes marked T (Toyota), N (Nissan) located on both sides of the unit
to fasten the unit to the factory radio mounting brackets supplied with your
vehicle.
Factory Radio
Mounting Bracket
Screw
Hook
Side View showing
Screw Holes marked
T, N
Screw
Dashboard or Console
78