Assembly Step - Vision Fitness T80 Owner's Manual

ASSEMBLY STEP 1

HARDWARE FOR STEP 1:
BOLT (A) SPRING WASHER (B)
20 mm 8.2 mm
Qty: 6 Qty: 6
RIGHT CONSOLE MAST
LEFT CONSOLE MAST
BOLTS (A)
SPRING WASHERS (B)
ARC WASHERS (C)
BASE FRAME
24
VF_12_T80_OM_rev1_7.indd 24-25
A Open HARDWARE FOR STEP 1.
B Attach LEAD WIRE to CONSOLE CABLE and pull
ARC WASHER (C)
LEAD WIRE through RIGHT CONSOLE MAST. After
8.4 mm
Qty: 6 pulling the LEAD WIRE through the mast, the top of
the CONSOLE CABLE should be located at the top
of the mast. Detach and discard LEAD WIRE.
NOTE: Do not pinch console cable when placing
the mast onto the base frame.
Attach CONSOLE MAST to BASE FRAME using
C
3 BOLTS (A), 3 SPRING WASHERS (B) and 3 ARC
WASHERS (C).
LEAD WIRE
NOTE: Do not tighten bolts until step 4 is complete.
CONSOLE CABLE
D Repeat step C on other side.
ASSEMBLY STEP 2
HARDWARE FOR STEP 2:
SPRING ARC
BOLT (A)
WASHER (B) WASHER (C)
20 mm
8.2 mm 8.4 mm
Qty: 6
Qty: 6 Qty: 4
CONSOLE CABLES
RIGHT HANDLEBAR
RIGHT CONSOLE MAST
BOLT (A)
SPRING WASHER (B)
FLAT WASHER (D)
ARC WASHERS (C)
Open HARDWARE FOR STEP 2.
A
B Guide CONSOLE CABLES from HANDLEBARS
FLAT
through and out of the tops of the CONSOLE
WASHER (D)
8.2 mm
MASTS.
Qty: 2
C Slide HANDLEBARS onto CONSOLE MASTS.
NOTE: Do not pinch console cables while attaching
the handlebars.
D Attach right HANDLEBAR to right CONSOLE
MAST using 1 FLAT WASHER (D), 1 SPRING
WASHER (B) and 1 BOLT (A) from the inside and
2 ARC WASHERS (C), 2 SPRING WASHERS (B)
and 2 BOLTS (A) from below.
NOTE: Do not tighten bolts until step 4 is complete.
Repeat on other side.
E
25
11/2/12 9:51 AM