Support Bar - Vision Fitness T80 Owner's Manual

ASSEMBLY STEP 3
HARDWARE FOR STEP 3:
ARC
SPRING
WASHER (E)
WASHER (B)
8.4 mm
8 mm
Qty: 4
Qty: 4
HANDLEBAR

SUPPORT BAR

BASE FRAME
26
VF_12_T80_OM_rev1_7.indd 26-27
Open HARDWARE FOR STEP 3.
A
Attach the right SUPPORT BAR to the BASE
BOLT (F) B
95 mm
FRAME using 1 ARC WASHER (E), 1 SPRING
Qty: 2
WASHER (B) and 1 BOLT (F).
BOLT (A)
20 mm
Qty: 2
NOTE: Do not tighten bolts until step 4 is complete.
C Attach the right SUPPORT BAR to the
HANDLEBAR using 1 ARC WASHER (E),
1 SPRING WASHER (B) and 1 BOLT (A).
Repeat on other side.
ARC WASHER (E) D
SPRING WASHER (B)
BOLT (A)
BOLT (F)
SPRING WASHER (B)
ARC WASHER (E)
ASSEMBLY STEP 4
HARDWARE FOR STEP 4:
ARC
SPRING
BOLT (A)
WASHER (E)
WASHER (B)
20 mm
8.4 mm
8.2 mm
Qty: 6
Qty: 6
Qty: 6
CONSOLE BASE
CONSOLE CABLES
BOLTS (A)
SPRING WASHERS (B)
ARC WASHERS (E)
CONSOLE
MAST
MAST COVERS
SCREWS (G)
SUPPORT BAR CAP
Open HARDWARE FOR STEP 4.
A
Gently place CONSOLE BASE on top of
B
SCREW (G)
CONSOLE MASTS.
12 mm
Qty: 8
NOTE: Be careful not to pinch the console
cables while attaching the console base.
C Connect the CONSOLE CABLES and tuck
them inside the CONSOLE MASTS and slide
CONSOLE BASE into CONSOLE MASTS.
Connect the CONSOLE BASE to CONSOLE
D
MASTS using 6 ARC WASHERS (E),
6 SPRING WASHERS (B) and 6 BOLTS (A).
NOTE: Tighten all bolts from STEPS 1–3.
Attach MAST COVERS to BASE FRAME
E
using 4 SCREWS (G).
Insert SUPPORT BAR CAP into bottom of
F
SUPPORT BAR.
G Repeat on other side.
27
11/2/12 9:51 AM