Removing The Pod (For Authorized Repair Only) - Humminbird 360 Imaging Installation Manual

Removing the Pod
Use the following instructions to remove the pod and send it to Humminbird® for
service.
WARNING! Do NOT remove the pod unless you have a repair authorization number from
our Customer Resource Center. Removing the pod without authorization will void the
warranty. See the Warranty and Service Policy for details.
NOTE: Place a table under the Transducer Deployment System so you have a surface to
support the removal of hardware as you work, or you might prefer to remove the Transducer
Deployment System from the transducer bracket and place it on a stable surface to work.
1. Contact the Customer Resource Department at service@humminbird.com
or 1-800-633-1468 to request a Repair Authorization Number.
2. Disconnect the power cable from the Transducer Deployment System.
3. Place your hands above the pod and pull down the deployment column, so
the pod is deployed approximately 6" (15 cm).
4. Hold the pod from the bottom so it is supported, and remove the two screws
from the top of the pod (see the illustration Removing the Screws).
Pulling Down the
Deployment Column

Removing the Pod (for authorized repair only)

(for authorized repair only)
Removing the
Screws
48