Table of Contents
Advertisement
WARNING! The pod should NOT be in the water during high speed travel. The
pod should only be deployed when the boat is traveling between 0 to 7 mph.
2. Set the Deployment Depth
The 360 Imaging™ transducer pod should be set to deploy past the hull, propeller, and
anything else that will block the beams.
1. From the Main Menu, select the Accessories tab > 360 Sonar Settings >
360 Depth.
2. Press the RIGHT or LEFT Cursor keys to adjust the setting. (1 to 100;
Default = 8)
NOTE: The 360 Depth setting deploys the transducer in increments of 1% to 100%,
where 100% = 29 inches (73.7 cm).
3. Press the EXIT key until the menu system is closed.
Deploying the Transducer Past All Beam Obstructions
35
Installation - Set up the Control Head
Deployment
Depth
Hide quick links:
Advertisement
Table of Contents
