Fishing System Defaults To Simulator With A Transducer Attached - Humminbird 360 Imaging Installation Manual

Fishing System Defaults to Simulator with a Transducer Attached

In addition to the 360 Imaging™ accessory transducer, you will have a standard
Humminbird® transducer connected to the control head. A connected and functioning
transducer will cause the newly-started Fishing System to go into Normal operating
mode automatically. If, when you power up the Fishing System, it goes into Simulator
mode automatically, even though a transducer is already connected, this means that
the control head is not detecting the transducer. Perform the following
troubleshooting tasks:
• Check the connections of all transducers that are connected to the control
head or Ethernet network. See the transducer installation guide that was
included with your Fishing System for connection information.
• Review this 360 Imaging™ installation guide to confirm that the transducer
cable is connected correctly to the Fishing System. Reconnect if necessary,
and power on the Fishing System again to see if this fixes the problem.
• Because the 360 Imaging™ transducer is on the network, it might take up to
a minute to be detected on the network. Use the 4-WAY Cursor Control key
to select Normal from the Start-Up Options Menu. In this guide, see Set up
the Control Head, Section 1. Power on and Confirm Connections.
• Replace the non-functioning transducer with a known good transducer if
available and power up the control head again.
• Check the transducer cable. Replace the transducer if the cable is damaged
or corroded.
45 Troubleshooting