906992 - 08-10-02.qxd 8/9/02 4:07 PM Page 2 WARNING: SOME DUST CREATED BY POWER SANDING, SAWING, GRINDING, DRILLING, AND OTHER CONSTRUCTION ACTIVITIES contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: ·...
906992 - 08-10-02.qxd 8/9/02 4:07 PM Page 3 Use safety equipment. Always wear eye protection. Dust mask, non- skid safety shoes, hard hat, or hearing protection must be used for appropriate conditions. TOOL USE AND CARE Use clamps or other practical way to secure and support the workpiece to a stable platform.
(1) battery charger, (2) battery pack, and (3) product using battery. CAUTION: To reduce risk of injury, a Delta ShopMaster charger should only be used to charge a Delta ShopMaster battery pack. Other types of batteries may burst causing personal injury and damage. Do not charge a...
Page 5
16. Do not charge battery in damp or wet locations. 17. Do not attempt to charge any other cordless tool or battery pack with the Delta ShopMaster charger. 18. Do not short across the terminals of the battery pack: EXTREMELY HIGH TEMPERATURES COULD CAUSE PERSONAL INJURY OR FIRE.
Drop off expended battery packs at your local replacement battery retailer, your local recycling center, or at a Delta Service Center (see list on back page of this manual). Applicable fees for the collection and recycling of these batteries (in the United States), have been paid to the RBRC ™...
Page 7
The “Drill” position is used for drilling and for driving very large screws. TWO-SPEED GEAR SHIFT The Model CL120 Cordless Drill/ Driver has a two-speed gear shift which...
906992 - 08-10-02.qxd 8/9/02 4:07 PM Page 8 DRIVER BIT STORAGE Convenient storage areas with retaining clip Fig. screwdriver bits are provided on each side of the tool. Fig. 4 OPERATION CHARGING THE BATTERY PACK GENERAL Before using your cordless Drill/Driver for the first time, the battery pack should be fully charged.
Page 9
906992 - 08-10-02.qxd 8/9/02 4:07 PM Page 9 Depending on room temperature, line voltage, and existing charge level, initial battery charging may take longer than six to eight hours. Disconnect charger from power source when not in use. INSTALLING OR REMOVING BATTERY PACK Fig.
906992 - 08-10-02.qxd 8/9/02 4:07 PM Page 10 If drill stalls or becomes jammed in the hole, release trigger immediately, remove drill bit from work and determine cause of stalling or jamming. DO NOT SQUEEZE TRIGGER ON AND OFF IN AN ATTEMPT TO FREE A STALLED OR JAMMED DRILL –...
Set screwdriver for reverse rotation. Place bit in screw and start drill to remove screw. HORIZONTAL BUBBLE LEVEL The Model CL120 is equipped with a horizontal level (A) Fig.9. The level can aid in drilling a horizontal hole. Fig. 9...
LUBRICATION For your continued safety and electrical protection, lubrication and service on this tool should ONLY be performed by an AUTHORIZED DELTA SERVICE STATION or a DELTA SERVICE CENTER. At approximately 100 hours of use, take or send your tool to your nearest Authorized Delta Service Station to be thoroughly cleaned and inspected;...
1-800-223-7278 (In Canada call 1-800-463-3582). Two Year Limited Warranty Delta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory which in normal use has proven to be defective in workmanship or material, provided that the customer returns the...