Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes - Chamberlain 1425E Owner's Manual

PROGRAMMING

NOTICE: If this Security✚
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional 315 MHz Security✚

To Add or Reprogram a Hand-held Remote Control

USING THE LIGHTED DOOR CONTROL (OPTIONAL)
1. Remove the cover from the lighted
door control.
2. Press and hold the button on the
hand-held remote* that you wish to
operate your garage door.
3. While holding the remote button, press
and hold the "A" button on the Lighted
Door Control.
4. Continue holding both buttons while
you press the "B" button on the
Lighted Door Control (all three buttons
are held).
5. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
To Erase All Codes From Motor Unit
Memory
To deactivate any unwanted remote,
first erase all codes:
Press and hold the "learn" button on
motor unit until the learn indicator light
goes out (approximately 6 seconds). All
previous codes are now erased.
Reprogram each remote or keyless entry you wish to use.
®
garage door opener is operated with a non-rolling code transmitter, the technical measure in
"B"
Button
USING THE DOOR CONTROL
"A"
Button
1. Press and hold the button on the
hand-held remote
operate your garage door.
2. While holding the remote button, press
and hold the LIGHT button on the door
control.
3. Continue holding both buttons while
you press the push bar on the door
"A"
control (all three buttons are held).
Button
"B"
Button
4. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
*3-Button Remote Controls (315 MHz)
If provided with your garage
door opener, the large
button is factory
programmed to operate it.
Additional buttons on any
®
Security✚
remote or mini-remote can
be programmed to operate
other Security✚
36
* that you wish to
multi-function
®
garage door openers.
® remote controls.