Applied Control - Toshiba MMK-AP0074MH-E Service Manual

7. APPLIED CONTROL

7-1. Setup of Selecting Function in Indoor Unit
(Be Sure to Execute Setup by a Wired Remote Controller)
<Procedure> Execute the setup operation while the unit stops.
3
5
6
1
1
CL
Push SET , , and
The firstly displayed unit No. indicates the header indoor unit address in the group control.
In this time, the fan of the selected indoor unit is turned on.
2
UNIT LOUVER
Every pushing
displayed. In this time, the fan of the selected indoor unit only is turned on.
3
Specify the CODE No. (DN) using the setup temperature
4
Select the setup data using the timer time
(When selecting the CODE No. (DN) to "
from " °C " to " °F " on the remote controller.)
5
Push SET button. (OK if display goes on.)
• To change the selected indoor unit, return to procedure
• To change the item to be set up, return to procedure
6
Pushing button returns the status to normal stop status.
TEST
TEMP.
TIMER SET
TIME
FILTER L L
RESET TEST SET
buttons simultaneously for 4 seconds or more.
TEST
button, the indoor unit numbers in the group control are successively
ON / OFF
FAN MODE
SAVE A A VENT
CL SWING/FIX UNIT LOUVER T
and
and buttons.
33
", change the temperature indication of the unit
2
.
3
.
31
4
2
buttons.