Table of Contents
Advertisement
4.4.6
LAN Connector Setting
L A N
L A N
L A N
LAN Connector Setting is setup LAN Connector Type.
This setting specifies which Network Connector is used, 10BASE-
2(BNC) or 10BASE-T(RJ-45). Default is automatic selection, so
usually this setting is not required. Only when, two cable is connected
or auto-detection is not operating, this setting is used.
C o n n e c t o r
A u t o
P r ess
La n dsca pe
C o n n e c t o r
1 0 B A S E - T
P r ess
La n dsca pe
C o n n e c t o r
1 0 B A S E - 2
P r ess
La n dsca pe
By pressing Landscape button, the setting is switched to
*Auto Detect→10BASE-T→10BASE-2.
By pressing Start button, set the LAN Connector Setting.
By pressing Stop button, cancel the LAN Connector Setting.
By pressing Start button, LAN Connector Type is set and returned to
initial screen.
By pressing Stop button, LAN Connector Type is canceled and
returned to initial screen.
Note: Factory default is 'Not Specified'.
T y p e
bu t t on
T y p e
bu t t on
T y p e
bu t t on
4 – 25
Advertisement
Table of Contents
