Oven Door Does Not Lock When The Oven Is Programmed For Clean - Electrolux 30" Service Manual

Oven door does not lock when the oven is pro-
grammed for clean:
1. Remove power from the range and go to the back of
the control and disconnect the P3 plug. Measure
the resistance between pins 3 and 4. If the meter
reads infinity check the oven door switch and the
wiring to the door switch. If the meter reads zero go
to step 2.
2. Measure the resistance between pins 1 and 3 of
plug P3. If the meter reads infinity switch A of the
lock motor assembly or the wiring to switch A is
defective. If the meter reads zero go to step 3.
3. Measure the resistance between pin 5 in plug P4
and terminal N. If the meter reads zero or infinity
the lock motor or the wiring to the lock motor is
defective. If the meter reads 2350 Ohms replace
the electronic oven control.
Oven door locks but the oven does not heat:
1. If the oven operates in normal bake remove power
and go to the back of the oven control. With the
door locked measure the resistance between pins 1
and 2 in plug P4. If the meter reads infinity switch A
of the lock motor assembly or the wiring to switch A
is defective. If the meter reads zero the electronic
oven control is defective.
Door latch is partly closed with door open:
1. Remove the right-hand bodyside, program the oven
for self-clean, and hold in on the door switch for 30
seconds. Touch cancel and hold door switch in for
30 seconds. The lock motor should lock and un-
lock the door.
97