For Models With Self-Clean Feature - Electrolux 30" Service Manual

• Never use your range for warming or heating
the room. Prolonged use of the range without
adequate ventilation can be dangerous.
• Do not store or use gasoline or other
flammable vapors and liquids near this or any
other appliance. Explosions or fires could result.
• Reset all controls to the "off" position after
using a programmable timing operation.

FOR MODELS WITH SELF-CLEAN FEATURE:

• Remove broiler pan, food and other utensils
before self-cleaning the oven. Wipe up excess
spillage. Follow the precleaning instructions in the
Owner's Guide.
Power Supply Cord Kit
The user is responsible for connecting the power
supply cord to the connection block located behind
the back panel access cover.
This appliance may be connected by means of
permanent "hard wiring" (flexible armored or
nonmetallic shielded copper cable), or by means of
a power supply cord kit. Use only a power supply
cord kit rated at 125/250 volts minimum, 40
amperes minimum and marked for use with ranges.
See chart (below) for cord kit connection opening
size and rating information. Cord must have either 3
or 4 conductors.
For mobile home installation or areas where local
codes do not permit grounding through neutral, a 4
conductor power supply cord kit rated at 125/250
volts minimum, 40 amperes minimum and marked
for use with ranges should be used (see Figure 4).
Terminals on end of wires must either be closed
loop or open-end spade lugs with upturned ends.
Cord must have strain relief clamp.
Range Connection Opening Size Chart
Refer to chart below for proper range connection opening
size and power supply cord kit ampere rating information. See
serial plate on range for kilowatt rating data.
Range Kilowatt Rating
(See Serial Plate on Range)
120/240 Volts 120/208 Volts
0 -16.5 kW 0 -12.5 kW
16.6-22.5 kW 12.6-18.5 kW
Diameter (inches) of
Minimum Range Connection
Cord kit Opening
Ampere Cord Kit Direct
Rating Connection
40 Amp 1-3/8 in. 1-1/8 in.
50 Amp 1-3/8 in. 1-3/8 in.
Risk of fire or electrical shock
exists if an incorrect size range cord kit is used,
if the Installation Instructions are not followed,
or if the strain relief bracket is discarded.
NOTE: Range is shipped from factory with 1 1/8" dia.
hole as shown in figure 3. If a larger hole is required,
punch out the knockout.
Figure 1
Electrical Connection to the Range
This appliance is manufactured with the neutral
terminal connected to the range.
While connecting range, do
not loosen the nuts which secure the terminal
block to the range. Electrical failure or loss of
electrical connection may occur.
Electrical Shock Hazard
• Electrical ground is required on this
appliance.
• Do not connect to the electrical supply until
appliance is permanently grounded.
• Disconnect power to the circuit breaker or
fuse box before making the electrical
connection.
24