Startup Help; Continuous Scan Mode - Honeywell HX3 User Manual

Startup Help

Contact Technical Assistance
HX3 seems to lockup as soon
as it is rebooted.
New HX3 main batteries don't
last more than a few hours.

Continuous Scan Mode

If Continuous Scan Mode has been enabled (factory default setting is 'Disabled'), the laser (or imager) is always on and
decoding.
Caution: Laser beam is emitted continuously. Do not stare into the laser beam.
if you need more help.
There may be slight delays while the wireless client connects to the network, authorization
for voice-enabled applications complete, Wavelink Avalanche management of the HX3
startup completes,and Bluetooth relationships establish or re-establish.
When an application begins, the HX3 is ready for use.
New batteries must be fully charged prior to first use. Li-Ion batteries (like all batteries) grad-
ually lose their capacity over time (in a linear fashion) and never just stop working. This is
important to remember – the HX3 is always 'on' even when in the Suspend state and draws
battery power at all times.
2-15