Page 12
Remove Trigger Module Remove Ring Strap Module Replace Ring Strap Module Replace Trigger Module...
Page 13
The only connection type is USB Client. Connect the HX3 end of the cable to the connector on the bottom of the HX3. Connect the USB type A connector on the I/O cable to a USB port on a PC or laptop.
Page 14
Using the Start menu, select Start > Run and type warmboot in the text box. Press Enter. When the HX3 is booting, there may be small delays while the wireless client connects, applications launch, remote management completes and Bluetooth devices connect.
Tap the Main tab. Wait for a radio connected message. Tap the Admin Logout button when finished. Reboot the HX3. Please refer to the Radio Mode parameter in the HX3 Reference Guide. It is important that this parameter setting corresponds to the Access Point to which the HX3 connects.
Disclaimer Honeywell International Inc. (“HII”) reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult HII to determine whether any such changes have been made.