Oki OKIPAGE 10ex Maintenance Manual page 37

The mode setting timing chart during illumination correction is shown below.
100ns min
CLOCKI
LOADI
DATAI0
STRB1I-N
STRB2I-N
STRB3I-N
STRB4I-N
The mode setting is carried out in the following manner. LOADI is fixed at high level, and DATAI0 which
comes up following this is 4-data latched with the timing of the fall of CLOCKI. The illumination correction
mode is selected based on the latched 4-data combination. Then the mode becomes valid at the fifth
fall of CLOCKI.
The period during which the illumination correction mode is valid is from the fall of the fifth CLOCKI and
while the level of LOADI is high. When the level of LOADI becomes low, the illumination correction mode
is terminated, and the head returns to the normal mode, which is mode with which the printing is normally
carried out.
40718401TH Rev.5
Illumination Correction Mode Setting Timing Chart
50ns 50ns
min min
D4 D3 D2 D1 D0
Mode setting
Mode set
200ns min
Mode enabled
100ns min
37 /