Table of Contents
Advertisement
12-2016.fm Page 14 Monday, April 10, 2000 4:33 PM
Note: If you have not already done
so, be sure to mark each wire with
the name of the terminal you will
reconnect it to.
3. Using the mounting holes on the
amplifier as a guide, mark the posi-
tions for the mounting holes.
1
4. Drill
/
-inch (3.5 mm) holes at the
8
marked locations, being careful not
to damage anything behind the
mounting surface.
ˆ Operation
TURNING ON THE
AMPLIFIER
The amplifier automatically turns on a
few seconds after you turn your vehi-
cle's ignition switch to ACC or ON or
turn on your auto sound system, de-
pending on how you wired the system.
The POWER indicator on the side of the
amplifier lights when the amplifier is on.
POWER Indicator
Important: Your amplifier requires 30
amps or more of power from your vehi-
cle's battery during operation. To protect
your battery from discharging, do not op-
erate the amplifier unless your vehicle is
running.
14
5. Secure the amplifier to the mounting
surface using the supplied sheet
metal screws and washers.
6. Reconnect the wiring.
7. Reconnect the cable to the vehicle
battery's negative (–) terminal.
8. Reset your vehicle's clock, your
auto sound system's tuner memory,
and other timer/memory devices.
Note: Your amplifier temporarily shuts
down if it gets too hot, then restarts au-
tomatically once it cools.
ADJUSTING THE AUDIO
LEVEL
For the best performance, you must set
LEVEL (MIN/MAX)
plifier to adjust the level of the audio sig-
nals that enter the amplifier.
1. Use a screwdriver to turn
fully counterclockwise to
(MIN/MAX)
.
MIN
2. Turn the auto sound system's vol-
ume control to about one-third of its
full range.
Operation
on the side of the am-
LEVEL
Hide quick links:
Advertisement
Table of Contents
