Configuring Redundancy Group Membership - Motorola WiNG 4.4 Reference Manual

5 - 42 WiNG 4.4 Switch System Reference Guide

5.4.3 Configuring Redundancy Group Membership

The redundancy group should be disabled to conduct an Add/Delete operation. There are a minimum of 2 members needed
to comprise a Redundancy Group, including the initiating switch
To configure switch redundancy memberships:
1. Select Services
The Redundancy screen displays with the Configuration tab selected.
2. Select the Member
3. Refer to the following information within the Member tab:
IP Address
Status
Last Seen
AP Adoption Count Displays the number of Access Ports adopted by this member.
> Redundancy from the main menu tree.
tab.
Displays the IP addresses of the redundancy group member.
Displays the current status of this group member. This status could have
the following values:
• Configured - The member is configured on the current wireless service
module.
• Seen - Heartbeats can be exchanged between the current switch and
this member.
• Invalid - Critical redundancy configuration parameter(s) of the peer
(heartbeat time, discovery time, hold time, Redundancy ID, Redundancy
Protocol version of this member) do not match this switch's parameters.
• Not Seen - The member is no more seen by this switch.
• Established - The member is fully established with this current module
and licensing information already been exchanged between this switch
and the member.
• Unknown - No status information could be obtained.
Displays the time when this member was last seen by the switch.