Adjusting The Burner - Viessmann VITOMAX 200-HS M73A Installation Instructions Manual

Mounting the burner
Note
If the burner plate was not pre-drilled at
the factory, drill the burner fixing holes
into the burner plate and cut the flame
head hole out with an oxy-acetylene
torch.
For max. flame head diameter, see table
on page 19.
315

Adjusting the burner

For burner adjustment, see the
separate burner documentation.
(cont.)
1. For the burner connection, secure the
2. Secure the burner to the burner
3. For different dimensions, adjust the
4. After fitting the burner, seal the annu-
5. Insert the turbulators (if available) as
6. Close the boiler doors and cleaning
burner plate to the boiler flange.
plate.
cut-out in the thermal insulation
according to the flame head diame-
ter.
lar gap between the flame head and
the thermal insulation block with
heat-resistant insulation (supplied in
the flame tube pack).
far as they will go.
aperture at the back of the boiler.
17