Accessories - Invacare rea Spirea4 NG User Manual

1.
A
Tool: 5 mm Allen key
2.
D
4.
E
Always use two anti-tip devices!

Accessories

Anti-tip device, swing away
The anti-tip device is foldable and both its height and
depth can be adjusted. Please pay particular attention
to how the anti-tip device is positioned when it is used.
There will be a warning sticker if the anti-tip device
has not been activated.
1. Assembly
Insert the two screws (A) into the holes of the
castor wheel attachment and fit them into the
holes of the anti-tip device. The height of the anti-
tip device is adjusted according to the holes that
are used. Screw tightly.
2. Adjusting the height
To adjust the height, press on the two buttons (B)
B on each side of the housing and pull the tube (C)
to the desired position (hole). The buttons will
lock the tube in the correct place.
C
3. Adjusting the depth
The depth is adjusted by pressing the button (D)
and pulling the tube to the desired depth. The
button will lock the tube in the correct place.
4. Swing mechanism
To turn the anti-tip device under the wheelchair,
press down the "hub" (E) and pull it to one side.
NB! A red sticker warns of a tipping risk.
To activate the anti-tip device turn it back into
place again. It will automatically lock into the right
position.
NB! _When the anti-tip device has been correctly
activated the red sticker will be concealed.
Do not use the buttons (B) to fold up the
anti-tip device.
The distance between the anti-tip device and
the ground as well as the distance between
the anti-tip device and the drive wheel should
be 5 cm.
Use your foot to fold up the anti-tip device. If you
use your hands there is a risk of getting them stuck
between the device and the tube.
Do not forget to fold out the anti-tip devices. The
wheelchair can tip over!
Check that the anti-tip devices are locked properly
before use.
25