Display Problems - HP OmniBook 4100 Reference Manual

Display Problems

If the OmniBook is on, but the screen is blank
• Press the space bar to see if the computer is in Standby mode.
• Press Fn+F1 or Fn+F2 to adjust the display. If you are using an external keyboard,
Fn = CTRL+ALT.
• Press Fn+F5 in case the internal display was disabled. (Do this three times to
return to the state you started from.)
• If the OmniBook is cold, allow it to warm up.
If the screen is difficult to read
• Check whether the display resolution is set to its default setting, 1024 × 768
(XGA). Check this in Start, Settings, Control Panel, Display, Settings.
• Check brightness (Fn+F2 to increase brightness).
Troubleshooting
Solving Problems
1-113