Venting Installation; Optional Top Vent Application - Vermont Castings 300DVB(N/P)(V/SC)7SB Installation And Operating Instructions Manual

Dvb series direct vent gas fireplace

Hide thumbs

Table Of Contents

Table of Contents

For models purchased after 4/16/15, please see addendum.

DVB Series Direct Vent Gas Fireplace

OPTIONAL TOP VENT APPLICATION

The appliance is shipped as a rear vent unit. If the installa-

tion layout requires the unit to be a top vent configuration

the appliance can be converted by following the steps

below.

When removing and refitting the plates and adapter be

sure the associated gaskets are undamaged and refitted

as required.

1. Remove the eight (8) screws securing the flue pipe

adapter to the fireplace body. Figure 7

2. Set the flue pipe adapter aside, complete with the

gasket. Do not damage the gaskets as the adapter and

gasket must be refitted.

3. Remove the eight (8) screws securing the flue pipe

cover to the top of the intake box and remove the cover

and gasket. Figure 7

Flue Pipe

Cover

Flue Pipe

Adapter

Figure 7 -

Remove 16 Screws from Flue Pipe Adapter and Flue

Pipe Cover

4. Remove six (6) screws securing the flue pipe to the

back of the intake box and remove the pipe and gasket.

Figure 8

5. Replace flue pipe to top of firebox. Ensure the gasket

FP1991

is in place and undamaged. Secure with six (6) screws.

remove screws

Figure 9

6. Place the flue pipe cover and gasket removed in step

3 over the flue opening in back of the intake box.

7. Refit the flue pipe adapter and gasket to the top of

fireplace. Secure the adapter with eight (8) screws re-

moved in Step 1.

After conversion to top vent configuration,

the 4" (102 mm) flue pipe should be

concentric within the 6

collar (within 1/4")

Screws

Flue Pipe

Figure 8 -

Remove Flue Pipe

Screws

FP1991

Figure 9 -

Attach Flue Pipe to Top Vent Configuration