Folding Seat - Mercedes-Benz Sprinter Operator's Manual

Seats
70
Removing/installing a two or three-seat
rear bench
Locking mechanism lever on the feet of the bench
seat
X
To remove the rear bench seat: swivel all
levers : of the bench seat upwards
completely.
The bench seat moves back into the seat
mounting recesses on the vehicle floor.
X
Lift the bench seat upwards out of the seat
mounting recesses.
X
To install the rear bench seat: observe
the specified installation position of the
bench seat.
Only install the two-seat rear bench on the
driver's side.
X
Examine seat mounting recesses ; on the
vehicle floor.
Seat mounting recesses ; must be kept
free from dirt and foreign objects.
X
Position the bench seat in the direction of
travel in the corresponding seat mounting
recesses ;.
X
Slide the bench seat forwards until you
hear the locking mechanisms engage.
X
Check levers : on the feet of the bench
seat.
All levers : must be flush to the vehicle
floor.

Folding seat

Folding seat (example with partition sliding door)
G
WARNING
When folding down the seat cushion, make
sure that nobody can become trapped.
If the key is inserted in the lock of the partition
sliding door the risk of injury to the co-driver
in the case of steering movements and in the
event of an accident is increased.
Remove the key of the partition sliding door
before using the folding seat.
X
Remove key : from the partition sliding
door.
X
Pull the handle of catch ; in the direction
of the arrow and fold seat cushion = up or
down.
X
Release handle ; when seat cushion =
has reached the respective end position.
X
Move seat cushion = until it locks into
place.
The handle of catch ; must be against the
seat frame.