Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for NCR WorldMark 4380
Summary of Contents for NCR WorldMark 4380
- Page 1 WorldMark™ 4380 Deskside Hardware Installation Guide B003-0181-A000 11/97...
- Page 2 NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current.
-
Page 3: Other Information Sources
Congratulations! And thank you for purchasing the NCR WorldMark 4380 Server. This document will guide you through the steps needed to set up your server for the first time. Note: No boards should be removed from or added to the server until after operating system installation is complete. - Page 4 – WorldMark 4300 Installing Windows NT Server – WorldMark 4300 Installing MP-RAS – WorldMark 4380 Deskside Product Guide – Server Software Guide (OctaSCALE) – System Site Log Remove the server off the pallet by the best means available (hoist or by hand). Place server in a...
- Page 5 When you are sure that you have the correct power cord, plug it into the server AC power connector. Do not plug the power cord into the wall outlet yet. WorldMark 4380 Deskside Hardware Installation Guide...
-
Page 6: Connect Peripherals
3. Connect Peripherals 3. Connect Peripherals IMPORTANT: Do not plug in the server before connecting peripherals. You need to install: • Keyboard • Video monitor • Mouse You must install a monitor and keyboard to configure the system. You may remove the monitor and keyboard after running the System Configuration Utility (SCU). - Page 7 For the server containing an SMB with an internal modem: • Run the external cable from “Comm In” to COM1 on the back of the chassis. • Connect your telephone line into the “Line” connector on the SMB. WorldMark 4380 Deskside Hardware Installation Guide...
- Page 8 4. Connect the Remote Support Modem For the server with an external modem, follow the procedures below. RJ11 connector to modem 25-pin connector to mode m Power supply connector to modem Connect to analog modem connection Connect Connect to to AC COM1 port power outlet on server...
-
Page 9: Connect The Network Cable
NUMBER SLOTS PCI slots on secondary system board PCI slots on primary system board Shared PCI/EISA slot on primary system board EISA slots on primary system board WorldMark 4380 Deskside Hardware Installation Guide... -
Page 10: Plug In The Power Cord
6. Plug in the Power Cord 6. Plug in the Power Cord The system requires up to three AC power receptacles as follows: Server 200-240 Vac Modem Power Supply 110/220 Vac (if applicable) Monitor 110/200 Vac Plug the server, modem power supply (as applicable), and monitor power cords into a grounded AC electrical outlet. -
Page 11: Turn On The System
Test) starts running. Wait until the following message displays: Press <D> to boot Diagnostic Partition Press <F1> for normal boot, <F2> for BIOS Setup Otherwise, <F1> is selected in 30 seconds PRESS “D” IMMEDIATELY. WorldMark 4380 Deskside Hardware Installation Guide... - Page 12 At the Confirm Exit message, select Yes. At the prompt, press any key to continue. 3. Press ESC until you reach the Main Menu on the “Welcome to NCR Utilities” screen. 4. Select the modem vendor by selecting the indicated options: Remote Support >...
- Page 13 Press D immediately to boot to the Diagnostic Partition. Select Run Utilities and Diagnostics to access the Diagnostic Partition. 11. You are now ready to call NCR to verify the remote support function. To call NCR: • Dial 1-800-531-2222 in the United States and Canada (other countries contact your local NCR representative for the remote support number in your area).
- Page 14 9. Install Your Operating System 9. Install Your Operating System Refer to the appropriate operating system installation guide and section to complete this step. For Windows NT Server, use: • WorldMark 4300 Installing Windows NT Server • Microsoft documentation For UNIX MP-RAS use: •...
- Page 15 For other types of service issues, follow these steps: 1. Call NCR at 1-800-262-7782 in the United States and Canada (other countries contact your local NCR representative for the remote support number in your area) 2.
- Page 16 9. Install Your Operating System...