Yamaha Vmax VMX17C 2009 Service Manual page 97

1. Thermostat inlet pipe (rear cylinder side)
2. Thermostat inlet hose (rear cylinder side)
3. Thermostat housing
4. Radiator cap
5. Thermostat inlet hose 2 (front cylinder side)
6. Coolant reservoir hose
7. Thermostat inlet pipe 2 (front cylinder side)
8. Thermostat inlet hose 1 (front cylinder side)
9. Thermostat inlet pipe 1 (front cylinder side)
10. Water pump outlet pipe
11. Water pump inlet pipe
12. Oil cooler inlet hose
13. Oil cooler outlet hose
14. Impeller shaft
A. Align the paint mark on the thermostat inlet pipe
(rear cylinder side) with the paint mark on the
thermostat inlet hose (rear cylinder side).
B. Align the paint mark on the thermostat inlet hose
(rear cylinder side) with the rib on the thermostat
housing.
C. Align the paint mark on the thermostat inlet hose 2
(front cylinder side) with the rib on the thermostat
housing.
D. Align the tape on the ignition coil sub-wire harness
2 with the paint mark on the thermostat inlet pipe 1
(front cylinder side) and then fasten the ignition coil
sub-wire harness 2 to the thermostat inlet pipe 1
(front cylinder side) with the plastic holder.
E. Align the paint mark on the thermostat inlet pipe 2
(front cylinder side) with the paint mark on the
thermostat inlet hose 1 (front cylinder side).
F. Align the paint mark on the thermostat inlet pipe 1
(front cylinder side) with the paint mark on the
thermostat inlet hose 1 (front cylinder side).
G. Align the paint mark on the thermostat inlet pipe 2
(front cylinder side) with the paint mark on the
thermostat inlet hose 2 (front cylinder side).
H. Install the oil cooler outlet hose with its paint mark
facing upward.
I. Align the paint mark on the water pump outlet pipe
with the paint mark on the oil cooler inlet hose.
COOLING SYSTEM DIAGRAMS
2-44