Table of Contents
Advertisement
Detach the terminal from the battery: the power supply from the
battery to the electrical system is cut off.
Warning
The battery quick release must only be used if the battery
conditioner cannot be connected.
Warning
Place the terminal so that it does not come into contact with the
battery terminal or other metal parts of the vehicle.
C
Reconnecting the battery
Place the clamp on the battery and fasten it by closing the locking
lever.
Each time the battery is reconnected, do the following before
starting the engine:
- close both doors and close the luggage compartment lid; unlock
and lock the doors using the remote control; open the luggage
compartment lid using the remote control;
- adjust the clock (date and time on instrument panel);
- close both doors and fully raise the driver side and passenger side
windows to their upper limit; check that the windows move down
to the "target position" when the doors are opened.
Warning
Before starting the engine, wait at least 60 second with the
ignition key in position II to allow the electronic system that
controls the motor-driven valves and the AC ECU to run a self-
acquisition process.
During this period, no devices must be activated.
The Motronic ECU self-acquisition cycle will only function correctly
when the intake air temperature is above 5 °C (41 °F).
After removing the battery from the vehicle or disconnecting it
from the electrical system using the battery master switch, it is
important to check that the external temperature is within the
indicated values when reconnecting before performing the self-
acquisition cycle.
Advice for Emergency Situations
5
213
Advertisement
Table of Contents
