Trg7000 Trigger Handle; Inserting The Eda Into The Trigger Handle; Removing The Eda - Motorola MC70 User Manual

6 - 14 MC70 User Guide

TRG7000 Trigger Handle

The TRG7000 Trigger Handle pistol grip accessory adds a gun-style handle with a scanning trigger to the EDA. It
increases comfort when using the EDA in scan-intensive applications for extended periods of time. The TRG7000
is intended for use with MC70 WLAN/PAN configurations.
Install the cleat onto the EDA before using the trigger handle. For cleat installation and communication setup
procedures refer to the MC70 Integrator Guide.

Inserting the EDA into the Trigger Handle

Slide the EDA into the Trigger Handle until it locks in place. The release secures the EDA to the Trigger Handle.
Figure 6-15 Inserting the EDA into the Trigger Handle

Removing the EDA

To remove the EDA, press the release down and pull the EDA forward.
Release
Figure 6-16 Removing the EDA
Release