Connecting The Subwoofer; Network Connection; Am/Fm Antenna Connections; Headphones Connection - Integra DTR-60.6 Basic Manual

Connecting the Subwoofer

Up to four subwoofers with built-in power amplifier can
be connected to the subwoofer jacks. Set the cut-off
filter selection switch of the subwoofer to DIRECT. If the
subwoofer does not have a cut-off filter selection switch
but has a cut-off frequency adjusting dial, turn it to the
maximum frequency.
Subwoofer with built-in
power amplifier
The speaker setting is 7.2 ch at the time of purchase. You
can change it manually or by using automatic speaker
setting.
Short-circuiting the + cable and - cable or contacting the
cable core to the rear panel of the unit may cause failure.
Also do not connect two or more cables to one speaker
terminal or one speaker to several terminals.
Using a speaker with less impedance than the setting
may result in failure.
When using commercially available banana plugs: tighten
the speaker terminals to the end and then insert the banana
plugs. Do not insert the cable core directly into the hole for
banana plug of speaker terminal. (North American model)
3
Other connections

AM/FM Antenna Connections

Connect the antennas to listen to AM/FM broadcast. When
listening to the broadcast for the first time, adjust the
antenna position and orientation to get the best reception.
AM loop
antenna
(supplied)
Indoor FM antenna
(supplied)
Fix with a tack on
the wall.
(North American models) (Australian models)
Assemble the AM loop antenna (supplied).
Step 1: Connections

Network Connection

You can enjoy Internet radio and DLNA by connecting the
unit to LAN. The unit can be connected to the router with an
Ethernet cable. Connect the Ethernet cable to the Ethernet
port.
Internet radio
Router

Headphones Connection

Sound from the speakers will be off while you are using the
headphones.
If you selected any other listening mode than Stereo,
Mono and Direct, connecting headphones will switch the
listening mode to Stereo.
PC
NAS
7