Honeywell HRHM1041 User Manual page 94

94 | Performance Series HQA Digital Video Recorder User Guide
To set up alarm input event actions
1.
2.
3.
4.
Configuring Network Alarm Inputs
A network alarm is an alarm signal originating from the TCP/IP network connection. You can use
NET SDK protocol to activate the network alarm.
To configure network alarm inputs, follow the same steps as for configuring local alarm inputs.
www.honeywell.com/security
On the Local Alarm tab, in the Anti-Dither box, specify the amount of time (5–600 s) to
delay the system's reaction to subsequent triggered alarms after the first alarm is
triggered. During the anti-dither time, if the system detects another alarm, the system will
not be initiate actions for that alarm.
Select the actions that you want the system to initiate when an alarm input is triggered
occurs:
• Alarm Out Select the check box to activate the selected alarm output(s) (1, 2, or 3).
In the Latch box, specify the amount of time (1–300 s) to delay the alarm
output signal after an alarm event is triggered.
• Show Message Select the check box to enable a pop-up message on your local host PC.
• Alarm Upload Select the check box to enable the system to upload an alarm signal to
the network (including to an alarm center and/or web client).
• Send Email Select the check box to enable the system to send an email notification.
If the Snapshot function is enabled, an image can be attached to the
email.
• Record Channel Select the channel(s) that you want to record. In the Delay box, specify
the amount of time (1–300 s) to delay recording after an alarm event is
triggered.
Note
• PTZ Activation Select the check box to activate PTZ functions, and then click Select. In
the PTZ Activation window, for each PTZ camera, select the preset,
tour, or pattern that you want to be called when an alarm event occurs,
and then click OK.
• Tour Select the check box to enable a tour of the selected channels.
• Snapshot Select the check box to take a snaphot of selected channels.
• Buzzer Select the check box to activate a buzzer noise at the DVR.
Click Apply to save your settings.
To copy the alarm event settings to additional channels, click Copy, select the channels
that you want to copy the settings to, and then click OK.
You also need to set the alarm recording period. Go to
Storage > Schedule to configure the current channel for
scheduled recording. See
Schedule on page 48.
Configuring the Video Recording